something adjustable (new-ueg)

[Mike Goetzke]

Dino - I must ask, why is the recessed area on your extrusions just a little to narrow to fit a 1/2" stick on rule?

Mike

[aaronp]

Originally Posted by Mike Goetzke

Dino - I must ask, why is the recessed area on your extrusions just a little to narrow to fit a 1/2" stick on rule?

Mike

Curious about this myself. I'm still awaiting a roll of EZ-ready stick-on rule I ordered years ago.

Most likely avoiding retooling fees, but I would think the originals would have needed replacing by now. Then again, I don't know what I'm talking about.

[Dino]

Originally Posted by Mike Goetzke

Dino - I must ask, why is the recessed area on your extrusions just a little to narrow to fit a 1/2" stick on rule?

Mike

Mike, It was taken off for the tapes at hand...mistake,
Not all tapes are exact and not all extruders are perfect...
my fault...trying to fix it with rigid vinyl printed strips for all extrusions.
At a price that we can all effort.

tx
d

[Dino]

Originally Posted by aaronp

Curious about this myself. I'm still awaiting a roll of EZ-ready stick-on rule I ordered years ago.

Most likely avoiding retooling fees, but I would think the originals would have needed replacing by now. Then again, I don't know what I'm talking about.

that stupid story stick....
it become an entire system for copying open areas ....
from floor tile to a door...

I first made one and I show it to a factory....
they managed to take the idea to the next step and now
is the most copied tool worldwide...

the ez story stick....

[tofu]

Originally Posted by Dino

Hi.
we are combining few ez parts and components...
looks like we are set for April. I hope the very first day or week at the latest.

Same time with the ez-Pyramids and our very own knobs to be able
to compete better or at least to keep prices from increases.

The aluminum extrusions are in 22-25 weeks delay...made in USA.
Wondering the effects of the new import taxes and the backlog of the parts
made in USA. We saw increases in few ez parts from US suppliers
due to import duties.. good luck to the small factories...

tx
d

Hi Dino,

Still on schedule for UEG and pyramid?

thanks

[bhough56]

Originally Posted by Mike Goetzke

Dino - I must ask, why is the recessed area on your extrusions just a little to narrow to fit a 1/2" stick on rule?

Mike

Mike,
I was thinking the same thing when I saw Dino was modifying dies and ordering new dies. I get to page three and there's your post! It seems like a really EZ fix. If the slot is made wider(say 9/16ths or even 5/8ths) it would take away any issues with different widths of rulers. Even if its to wide, wouldn't that be better than too narrow. This would also save on aluminum in the extruding process and who knows it might even allow for a price reduction on the tracks!

Bruce