View Single Post
  #40  
Old 02-10-2018, 04:30 PM
tomp913 tomp913 is offline
 
Join Date: Jul 2013
Posts: 250
Default

Thanks Dino.

I had the idea of making the fixture as a molded plastic part, should be an easy (and cheap) mold to make, and supply one with each base. This would allow you to eliminate the "fingers" on the base - I'm assuming that the molds to include the fingers were expensive, plus I'm sure that there are a percentage of parts where the fingers get damaged or broken off in shipping and handling. The separate gauge would be a simple solution. Plus, your customer would have an easy way of switching the base to another saw while still keeping the required 3" distance.

Tom
Reply With Quote